RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Configuring the Distribution of Prefix Lists 495
3. [Optional] Enable the neighbor as a route reflector client by configuring the following parameter:
Parameter Description
enabled If enabled and Route Reflector enabled, makes this neighbor a client for Route Reflector.
4. [Optional] Configure the route map settings by configuring the following parameter(s):
Parameter Description
in { in } Synopsis: A string
Apply route map to incoming routes.
out { out } Synopsis: A string
Apply route map to outbound routes.
5. [Optional] Configure the neighbor settings by configuring the following parameter(s):
Parameter Description
remote-as { remote-as } Synopsis: A 32-bit unsigned integer between 1 and 65535
A BGP neighbor.
This parameter is mandatory.
ebgp-multihop { ebgp-multihop } Synopsis: An 8-bit unsigned integer between 1 and 255
The maximum hop count. This allows EBGP neighbors not on directly connected
networks.
maximum-prefix { maximum-prefix } Synopsis: A 32-bit unsigned integer between 1 and 4294967295
The maximum prefix number accepted from this peer.
next-hop-self Disables the next hop calculation for this neighbor.
password { password } Synopsis: A string 1 to 1024 characters long
Password.
update-source { update-source } Synopsis: A string 7 to 15 characters long
Source IP address of routing updates.
disable-connected-check Disables connection verification when establishing an eBGP peering session with a
single-hop peer that uses a loopback interface.
soft-reconfiguration Per neighbor soft reconfiguration.
weight { weight } Synopsis: A 16-bit unsigned integer
The default weight for routes from this neighbor.
6. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.8.6.3
Configuring the Distribution of Prefix Lists
To configure the distribution of prefix lists for a neighbor in a BGP network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Apply the desired prefix list the chosen route direction (incoming or outbound) by typing:
routing bgp neighbor address distribute-prefix-list [ in | out ] prefix-list prefix
To Next Page
Loading...
Need help?
General
