RUGGEDCOM ROX II
CLI User Guide
Chapter 12
Tunneling and VPNs
Deleting a Session 385
Parameter Description
Lower value of cookie. This value must match with low-value of other endpoint's remote
cookie
high-value { high-value } Synopsis: A 32-bit unsigned integer
Higher value of cookie if the cookie size is 8. This value must match with high-value of
other endpoint's remote cookie
IMPORTANT!
Configuration of the remote cookie should match the configuration of the local cookie on the
device at the other end of the L2TPv3 tunnel.
5. Type remote-cookie and then configure the following parameters as required:
Parameter Description
size { size } Synopsis: { 4, 8 }
Cookie size in byte
low-value { low-value } Synopsis: A 32-bit unsigned integer
Lower value of cookie. This value must match with low-value of other endpoint's local
cookie
high-value { high-value } Synopsis: A 32-bit unsigned integer
Higher value of cookie if its size is 8. This value must match with high-value of other
endpoint's local cookie
6. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section12.4.5.3
Deleting a Session
To delete a session for a static or dynamic L2TPv3 tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the tunnel by typing:
no tunnel l2tpv3 [ static | dynamic ] tunnel tunnel-name session tunnel-session
Where:
• tunnel-name is the name of the tunnel
• tunnel-session is the name of the tunnel session
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
To Next Page
Loading...
Need help?
General
