Siemens RUGGEDCOM ROX II

RUGGEDCOM ROX II
CLI User Guide
Chapter 8
Layer 2
Adding a Router Port 297
Section8.4.3.3
Adding a Router Port
To add a router port for IGMP snooping, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the router port by typing:
switch mcast-filtering igmp-snooping router-ports slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section8.4.3.4
Deleting a Router Port
To delete a router port for IGMP snooping, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the router port by typing:
no switch mcast-filtering igmp-snooping router-ports slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section8.4.4
Managing the Static Multicast Group Table
This section describes how to manage entries in the Static Multicast Group table.
CONTENTS
• Section8.4.4.1, “Viewing a List of Static Multicast Group Entries”
• Section8.4.4.2, “Adding a Static Multicast Group Entry”
• Section8.4.4.3, “Deleting a Static Multicast Group Entry”
Section8.4.4.1
Viewing a List of Static Multicast Group Entries
To view a list of entries for known static multicast groups on other devices, type:
show running-config switch mcast-filtering static-mcast-table