Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
532 Adding a Route Map Filter Entry
Section13.9.6.4
Adding a Route Map Filter Entry
To add an entry for an route map filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the new filter by typing:
• For Standard OSPF Routes
routing ospf filter route-map tag entry number
• For VRF Routes via OSPF
routing ospf vrf vrf filter route-map tag entry number
Where:
• vrf is the name of the chosen VRF
• tag is the tag for the route map filter
• number is the sequence number for the entry
3. Configure the following parameter(s) as required:
Parameter Description
action { action } Synopsis:  { deny, permit }
Default:  permit
Action.
call { call } Synopsis:  A string
Jump to another route-map after match+set.
on-match-goto { on-match-goto } Synopsis:  A string
Go to this entry on match.
Parameter Description
metric { metric } Synopsis:  A 32-bit unsigned integer
Metric value.
metric-type { metric-type } Synopsis:  An 8-bit signed integer between 1 and 2
External route type.
4. Configure the match rules for the route map filter. For more information, refer to Section13.9.6.7,
“Configuring Match Rules”.
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.9.6.5
Deleting a Route Map Filter
To delete a route map filter for dynamic OSPF routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the filter key by typing:
• For Standard OSPF Routes
no routing ospf filter route-map tag

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English