Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
552
Viewing the Status of the LDP Neighbor Local Node
Information
If LDP discovery interfaces have been configured, a table similar to the following example appears:
ruggedcom# show mpls ldp status discovery
status discovery
local id 4.4.4.4
interfaces
INTERFACE SRC IP ADDR PEER ID PEER IP STATE
---------------------------------------------------------
switch.0010 192.168.10.2 2.2.2.2 192.168.10.1 OPER
switch.0020 192.168.20.1 6.6.6.6 192.168.20.2 OPER
This table provides the following information:
Parameter Description
interface Synopsis:  A string
The LDP discovery interface.
src-ip-addr Synopsis:  A string
The LDP discovery source IP address.
peer-id Synopsis:  A string
The LDP discovery peer ID.
peer-ip Synopsis:  A string
LDP discovery peer IP address
state Synopsis:  A string
The LDP discovery interface state.
For more information about configuring LDP discovery interfaces, refer to Section13.10.7.9, “Enabling/Disabling
an LDP Interface”.
Section13.10.7.3
Viewing the Status of the LDP Neighbor Local Node Information
To view the status of the local node(s) for the LDP neighbor on the device, type:
show mpls ldp status neighbor local-node-information
A table or list similar to the following example appears:
ruggedcom# show mpls ldp status neighbor local-node-information
KEEPALIVE
LDP ID HOLDTIME INTERVAL
------------------------------
4.4.4.4 15s 180s
This table or list provides the following information:
Parameter Description
ldp-id Synopsis:  A string
The LDP ID of the neighbor local node.
hello-holdtime Synopsis:  A string
LDP hello holdtime of the neighbor local node.
session-holdtime Synopsis:  A string
The LDP session holdtime of the neighbor local node.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English