Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 6
Security
Adding a Host 197
!
If no hosts have been configured, add hosts as needed. For more information, refer to Section6.9.11.2, “Adding a
Host”.
Section6.9.11.2
Adding a Host
To add a new host for a firewall, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the host by typing:
security firewall fwconfig firewall fwhost name
Where:
• firewall is the name of the firewall
• name is the name of the host
3. Configure the host by typing the following commands:
Parameter Description
ipsec Synopsis:  { true, false }
Default:  false
Parameter Description
iptype { iptype } Synopsis:  { ipv4, ipv6, ipv4ipv6 }
Default:  ipv4
Internet protocol type - use both when no addresses are used, otherwise define IPv4 and
IPv6 rules for each type of addresses used.
zone { zone } Synopsis:  A string
A pre-defined zone
This parameter is mandatory.
interface { interface } Synopsis:  A string
A pre-defined interface to which optional IPs and/or networks can be added.
This parameter is mandatory.
ipaddress { ipaddress } Synopsis:  A string
Additional IP addresses or networks - comma separated, or a range in the form of
low.address-high.address
description { description } Synopsis:  A string
(Optional) The description string for this host.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.9.11.3
Deleting a Host
To delete a host, do the following:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English