Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 6
Security
Deleting a Public Key 179
Section6.8.6.4
Deleting a Public Key
To delete an unsigned public key, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the public key by typing:
no security crypto public-key name
Where name is the name of the public key
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.8.7
Managing Certificates
This section describes how to manage certificates on the device.
CONTENTS
• Section6.8.7.1, “Viewing a List of Certificates”
• Section6.8.7.2, “Viewing the Status of a Certificate”
• Section6.8.7.3, “Adding a Certificate”
• Section6.8.7.4, “Deleting a Certificate”
Section6.8.7.1
Viewing a List of Certificates
To view a list of certificates, type:
show running-config security crypto certificate
If certificates have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security crypto certificate
security
crypto
certificate cert
contents "{--contents--}"
private-key-name key
ca-name ca-cert
!
!
!
If no certificates have been configured, add certificates as needed. For more information, refer to Section6.8.7.3,
“Adding a Certificate”.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English