To Next Page

To Previous Page

Chapter 6

Security

RUGGEDCOM ROX II

CLI User Guide

200 Configuring the Source Zone

Parameter Description

(Optional) The description string for this policy.

4. Configure the source zone for the policy. For more information, refer to Section6.9.12.3, “Configuring the

Source Zone”.

5. Configure the destination zone for the policy. For more information, refer to Section6.9.12.4, “Configuring

the Destination Zone”.

6. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Section6.9.12.3

Configuring the Source Zone

To configure the source zone for a firewall policy, do the following:

1. Make sure the CLI is in Configuration mode.

2. Navigate to security» firewall» fwconfig» {firewall}» fwpolicy» {policy}» source-zone, where {firewall}

is the name of the firewall and {policy} is the name of the policy.

3. Configure the following parameter(s) as required:

Parameter Description

predefined-zone { predefined-zone } Synopsis:  A string

all

4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Section6.9.12.4

Configuring the Destination Zone

To configure the destination zone for a firewall policy, do the following:

1. Make sure the CLI is in Configuration mode.

2. Configure the following parameter(s) as required:

Parameter Description

predefined-zone { predefined-zone } Synopsis:  A string

all

3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Section6.9.12.5

Deleting a Policy

To delete a policy, do the following:

1. Make sure the CLI is in Configuration mode.

2. Delete the policy by typing:

Siemens RUGGEDCOM ROX II User Manual

Questions and Answers: