Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 4
Device Management
Deleting a Remote Server 79
Section4.10.5.3
Deleting a Remote Server
To delete a remote server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the remote server by typing:
no admin logging server address
Where:
• address is the IP address of the remote server.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section4.10.6
Managing Remote Server Selectors
Remote server selectors filter the information sent to specific servers.
CONTENTS
• Section4.10.6.1, “Viewing a List of Remote Server Selectors”
• Section4.10.6.2, “Adding a Remote Server Selector”
• Section4.10.6.3, “Deleting a Remote Server Selector”
Section4.10.6.1
Viewing a List of Remote Server Selectors
To view a list of remote server selectors, type:
show running-config admin logging server address selector
Where:
• address is the IP address of the remote server.
If remote server selectors have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin logging server 172.30.144.254 selector
admin
logging
server 172.30.144.254
selector 1
no negate
facility-list [ all ]
!
!
!
!
If no remote server selectors have been configured, add selectors as needed. For more information, refer to
Section4.10.6.2, “Adding a Remote Server Selector”.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English