Siemens RUGGEDCOM ROX II User Manual

Chapter 12
Tunneling and VPNs
RUGGEDCOM ROX II
CLI User Guide
368 Adding an In/Out Interface
Section12.1.7.2
Adding an In/Out Interface
To add an in/out interface that can be used by a virtual switch filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the in/out interface by typing:
security virtualswitch-filter virtualswitch name rule rule [ in-interface | out-interface ]
interface
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
• interface is the name of the interface
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section12.1.7.3
Deleting an In/Out Interface
To delete an in/out interface that can be used by a virtual switch filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
no security virtualswitch-filter virtualswitch name rule rule [ in-interface | out-interface ]
interface
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
• interface is the name of the interface
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section12.1.8
Managing VLANs for Virtual Switches
This section describes how to configure and manage VLANs for virtual switches.
CONTENTS
• Section12.1.8.1, “Viewing a List of Virtual Switch VLANs”
• Section12.1.8.2, “Adding a Virtual Switch VLAN”
• Section12.1.8.3, “Deleting a Virtual Switch VLAN”

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English