Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 14
Network Redundancy
Selecting a Default Dedicated Link 619
1. Make sure the CLI is in Configuration mode.
2. Delete the dedicated link by typing:
no services conn-sync dedicated-link name
Where name is the name of the dedicated link.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section14.1.10.6
Selecting a Default Dedicated Link
To select a default a dedicated link, do the following:
1. Make sure the CLI is in Configuration mode.
2. Set the default dedicated link by typing:
services conn-sync default-dedicated-link link
Where link is the name of the default dedicated link.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section14.1.10.7
Viewing the Status of Each Dedicated Link
To view the status of all dedicated links, do the following:
1. Make sure the CLI is in Configuration mode.
2. To view the status of all dedicated links, type the following:
show services conn-sync status
A list similar to the following example appears:
ruggedcom# show services conn-sync status
status fe-2-3
state NO-CARRIER
role ACTIVE
byte sent 3614860
byte received 0
packet sent 114224
packet received 0
error sent 0
error received 0
status fe-2-4
state NO-CARRIER
role BACKUP
byte sent 0
byte received 0
packet sent 0
packet received 0
error sent 0
error received 0
The list provides the following information:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English