Siemens RUGGEDCOM ROX II User Manual

Chapter 8
Layer 2
RUGGEDCOM ROX II
CLI User Guide
314 Deleting a Forbidden Port
Where:
• name is the name of the static VLAN
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section8.5.6.3
Deleting a Forbidden Port
To delete a forbidden port, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to switch» vlans» static-vlan» {name}» forbidden-ports, where {name} is the name of the static
VLAN.
3. Configure the following parameter(s) as required:
no switch vlans static-vlan name forbidden-ports slot port
Where:
• name is the name of the static VLAN
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section8.5.7
Managing VLANs for Interfaces and Tunnels
This section describes how to view, add and delete tunnels for specific interfaces and tunnels.
• Section12.1.8, “Managing VLANs for Virtual Switches”
• Section12.4.6, “Managing VLANs for L2TPv3 Tunnels”
• Section4.18.3, “Managing VLANs for Routable Ethernet Ports”

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English