Siemens RUGGEDCOM ROX II

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
574 Configuring the Distribution of Prefix Lists
Parameter Description
send-community { send-community } Synopsis:  { standard, extended, both, none }
Default:  both
Identifies the send Community. Default is both.
remote-as { remote-as } Synopsis:  A 32-bit unsigned integer between 1 and 65535
A BGP neighbor.
This parameter is mandatory.
ebgp-multihop { ebgp-multihop } Synopsis:  An 8-bit unsigned integer between 1 and 255
The maximum hop count. This allows EBGP neighbors not on directly connected
networks.
maximum-prefix { maximum-prefix } Synopsis:  A 32-bit unsigned integer between 1 and 4294967295
The maximum prefix number accepted from this peer.
next-hop-self Disables the next hop calculation for this neighbor.
password { password } Synopsis:  A string 1 to 1024 characters long
Password.
update-source { update-source } Synopsis:  A string 7 to 15 characters long
Source IP address of routing updates.
disable-connected-check Disables connection verification when establishing an eBGP peering session with a
single-hop peer that uses a loopback interface.
soft-reconfiguration Per neighbor soft reconfiguration.
weight { weight } Synopsis:  A 16-bit unsigned integer
The default weight for routes from this neighbor.
4. Configure the route map settings by configuring the following parameter(s):
Parameter Description
in { in } Synopsis:  A string
Apply route map to incoming routes.
out { out } Synopsis:  A string
Apply route map to outbound routes.
5. Configure the prefix list distribution. For more information, refer to Section13.11.12.3, “Configuring the
Distribution of Prefix Lists”.
6. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.11.12.3
Configuring the Distribution of Prefix Lists
To configure the distribution of prefix lists for a neighbor in an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Apply the desired prefix list the chosen route direction (incoming or outbound) by typing:
routing bgp address-family ipv4 vrf vrf neighbor address distribute-prefix-list [ in | out ]
prefix-list prefix