Siemens RUGGEDCOM ROX II User Manual

Chapter 14
Network Redundancy
RUGGEDCOM ROX II
CLI User Guide
616 Deleting a Virtual IP Address
2. Add the instance by typing:
services vrrp instance name vrip address
Where:
• name is the name of the VRRP instance
• address is the address and subnet
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section14.1.9.3
Deleting a Virtual IP Address
To delete a virtual IP address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the virtual IP address by typing:
no services vrrp instance name vrip address
Where:
• name is the name of the VRRP instance
• address is the virtual IP address and netmask
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section14.1.10
Managing Connection Synchronization
This section describes how to configure connection synchronization between two VRRP-enabled routers.
CONTENTS
• Section14.1.10.1, “Configuring Connection Synchronization”
• Section14.1.10.2, “Enabling/Disabling Connection Synchronization”
• Section14.1.10.3, “Viewing a List of Dedicated LInks”
• Section14.1.10.4, “Adding a Dedicated Link”
• Section14.1.10.5, “Deleting a Dedicated Link”
• Section14.1.10.6, “Selecting a Default Dedicated Link”
• Section14.1.10.7, “Viewing the Status of Each Dedicated Link”
Section14.1.10.1
Configuring Connection Synchronization
To configure connection synchronization, do the following for each VRRP-enabled device:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English