Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 8
Layer 2
Configuring a Switched Ethernet Port 269
depended on it and potentially invalidate parts of the device configuration. For example, if a
switched Ethernet port is a trunk port, changing it to dedicated routing mode will automatically
remove it from the trunk and, therefore, make the trunk invalid. A trunk must consist of two trunk
ports.
NOTE
Switched Ethernet ports in dedicated routing port mode cannot be trunk ports.
NOTE
The configuration for a switched Ethernet port in switchport mode can be restored when it is
removed from a trunk. However, the configuration cannot be restored if the port is in dedicated
routing mode.
Parameter Description
enabled Synopsis:  { true, false }
Default:  true
Provides the option to enable or disable this interface. When unchecked(i.e disabled), the
interface will prevent all frames from being sent and received on that interface.
auton { auton } Synopsis:  A string
Enables or disables IEEE 802.3 auto-negotiation. Enabling auto-negotiation results in
speed and duplex being negotiated upon link detection; both end devices must be auto-
negotiation compliant for the best possible results.
This parameter is mandatory.
speed { speed } Synopsis:  A string
Speed (in megabits-per-second or gigabits-per-second). If auto-negotiation is enabled,
this is the speed capability advertised by the auto-negotiation process. If auto-
negotiation is disabled, the port is explicitly forced to this speed mode. AUTO means
advertise all supported speed modes.
This parameter is mandatory.
duplex { duplex } Synopsis:  A string
If auto-negotiation is enabled, this is the duplex capability advertised by the auto-
negotiation process. If auto-negotiation is disabled, the port is explicitly forced to this
duplex mode. AUTO means advertise all supported duplex modes.
This parameter is mandatory.
link-alarms Synopsis:  { true, false }
Default:  true
Disabling link-alarms will prevent alarms and LinkUp and LinkDown SNMP traps from
being sent for that interface. Link alarms may also be controlled for the whole system
under admin / alarm-cfg.
switchport Synopsis:  { true, false }
Sets the physical port into either switched mode or a dedicated routing mode.
flow-control Flow control is useful for preventing frame loss during times of severe network traffic
on-demand Bring up this interface on-demand only
ip-address-src { ip-address-src } Synopsis:  { static, dynamic }
Default:  static
Whether the IP address is static or dynamically assigned via DHCP or BOOTP. Option
DYNAMIC is a common case of a dynamically assigned IP address. It switches between
BOOTP and DHCP until it gets the response from the relevant server. This must be static
for non-management interfaces.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English