Siemens RUGGEDCOM ROX II - Page 509

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Viewing the Status of Dynamic RIP Routes 463
192.168.50.0/24 connected interface 0.0.0.0 1 self 0
192.168.60.0/24 connected interface 0.0.0.0 1 self 0
This list provides the following information:
Parameter Description
network Synopsis:  A string
The network.
type Synopsis:  A string
The route type.
sub-type Synopsis:  A string
The route sub type.
next-hop Synopsis:  A string
The next hop.
metric Synopsis:  A string
The metric value.
from Synopsis:  A string
Where this route comes from.
tag Synopsis:  A string
Tag.
time Synopsis:  A string
The route update time.
To view the status of the RIP interfaces configured on the device, type:
show routing status rip interface
If RIP interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status rip interface | tab
NEXT
NAME NETWORK TYPE SUB TYPE HOP METRIC FROM TAG TIME
--------------------------------------------------------------------------------------
switch.1112
192.168.11.0/24 connected interface 0.0.0.0 1 self 0
This list provides the following information:
Parameter Description
network Synopsis:  A string
The network.
type Synopsis:  A string
The route type.
sub-type Synopsis:  A string
The route sub type.
next-hop Synopsis:  A string
Next hop.
metric Synopsis:  A string
The metric value.