Cisco ONS 15454 DWDM - Page 15

Contents
xv
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
NTP- G91 Modify OPT-PRE and OPT-BST Line Settings and PM Parameters and Thresholds 11-12
DLP- G204 Change Optical Line Settings for OPT-PRE and OPT-BST Amplifiers 11-12
DLP- G205 Change Optical Line Threshold Settings for OPT-PRE and OPT-BST Amplifiers 11-14
DLP- G206 Change Optical Amplifier Line Settings for OPT-PRE and OPT-BST Amplifiers 11-16
DLP- G207 Change Optical Channel Threshold Settings for OPT-PRE and OPT-BST Amplifiers 11-18
DLP- G322 Change the OPT-BST ALS Maintenance Settings 11-22
NTP- G92 Modify 32MUX-O, 32DMX-O, 32DMX, and 4MD Line Settings and PM Thresholds 11-23
DLP- G208 Change Optical Line Settings for Multiplexer and Demultiplexer Cards 11-24
DLP- G209 Change Optical Line Threshold Settings for Multiplexer and Demultiplexer Cards 11-26
DLP- G210 Change Optical Channel Settings for Multiplexer and Demultiplexer Cards 11-27
DLP- G211 Change Optical Channel Threshold Settings for Multiplexer and Demultiplexer
Cards
11-30
NTP- G93 Modify the 32WSS Thresholds and Settings 11-33
DLP- G212 Change Optical Channel Parameters for the 32WSS Card 11-33
DLP- G213 Change the 32WSS Optical Channel Thresholds 11-36
DLP- G214 Change Optical Line Parameters for the 32WSS Card 11-39
DLP- G215 Change the 32WSS Card Optical Line Thresholds 11-40
NTP- G101 Modify Alarm Interface Controller–International Settings 11-42
DLP- G245 Change External Alarms Using the AIC-I Card 11-42
DLP- G246 Change External Controls Using the AIC-I Card 11-43
DLP- G247 Change AIC-I Card Orderwire Settings 11-44
NTP- G102 Change Card Service State 11-45
CHAPTER 12 Add and Remove Cards and Nodes 12-1
Before You Begin 12-1
NTP- G107 Remove and Replace DWDM Cards 12-1
DLP- G254 Place OPT-BST and OPT-PRE Ports Out of Service 12-3
DLP- G318 Place OPT-BST and OPT-PRE Ports In Service 12-4
NTP- G127 Add an AD-xC-xx.x Card to an OADM Node 12-5
NTP- G129 Add a DWDM Node 12-7
NTP- G130 Remove a DWDM Node 12-9
CHAPTER 13 Maintain the Node 13-1
Before You Begin 13-1
NTP- G103 Back Up the Database 13-2
NTP- G104 Restore the Database 13-3
NTP- G105 Restore the Node to Factory Configuration 13-4