Contents
xiv
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
NTP- G84 Initiate and Clear Y-Cable and Splitter External Switching Commands 10-34
DLP- G178 Apply a Manual Y-Cable or Splitter Protection Switch 10-35
DLP- G179 Apply a Force Y-Cable or Splitter Protection Switch 10-35
DLP- G180 Clear a Manual or Force Y-Cable or Splitter Protection Switch 10-36
DLP- G181 Apply a Lock-On 10-37
DLP- G182 Apply a Lockout 10-37
DLP- G183 Clear a Lock-On or Lockout 10-38
NTP- G85 Modify or Delete OSC Terminations, GCC Terminations, and Provisionable Patchcords 10-39
DLP- G184 Change a GCC Termination 10-40
DLP- G185 Delete a GCC Termination 10-40
DLP- G186 Delete an OSC Termination 10-41
DLP- G187 Delete a Provisionable Patchcord 10-42
NTP- G86 Convert a Pass-Through Connection to an Add/Drop Connection 10-42
NTP- G87 Change Node Timing Parameters 10-44
NTP- G88 Modify Users and Change Security 10-45
DLP- G188 Change Security Policy for a Single Node 10-46
DLP- G189 Change Security Policy for Multiple Nodes 10-47
DLP- G317 Change Node Access and PM Clearing Privilege 10-49
DLP- G191 Change User Password and Security Level on a Single Node 10-50
DLP- G192 Change User Password and Security Level for Multiple Nodes 10-51
DLP- G193 Delete a User From a Single Node 10-52
DLP- G194 Delete a User From Multiple Nodes 10-52
DLP- G195 Log Out a User on a Single Node 10-53
DLP- G196 Log Out a User on Multiple Nodes 10-54
DLP- G281 Configure the Node for RADIUS Authentication 10-55
DLP- G282 View and Terminate Active Logins 10-57
NTP- G131 Convert DWDM Nodes to Hybrid Nodes 10-58
NTP- G89 Change SNMP Settings 10-61
DLP- G197 Modify SNMP Trap Destinations 10-61
DLP- G198 Delete SNMP Trap Destinations 10-62
CHAPTER
11 Change DWDM Card Settings 11-1
Before You Begin 11-1
NTP- G90 Modify OSCM and OSC-CSM Line Settings and PM Parameters and Thresholds 11-2
DLP- G199 Change the OSCM and OSC-CSM Optical Service Channel Settings 11-2
DLP- G200 Change the OSCM and OSC-CSM Optical Service Channel Thresholds 11-5
DLP- G201 Change Optical Line Parameters for OSCM and OSC-CSM Cards 11-6
DLP- G202 Change the OSCM and OSC-CSM Optical Line Threshold Settings 11-8
DLP- G203 Change the OSCM and OSC-CSM ALS Maintenance Settings 11-10
To Next Page
Loading...
