Cisco ONS 15454 DWDM - Page 30

Figures
xxx
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Figure 3-1 Cisco MetroPlanner Shelf Layout 3-4
Figure 3-2 Selecting the IP Address Option 3-15
Figure 3-3 Changing the IP Address 3-15
Figure 3-4 Selecting the Save Configuration Option 3-16
Figure 3-5 Saving and Rebooting the TCC2/TCC2P 3-16
Figure 3-6 Nodes Behind a Firewall 3-23
Figure 3-7 CTC Computer and ONS 15454 Nodes Residing Behind Firewalls 3-24
Figure 3-8 Creating an SNMP Trap 3-36
Figure 3-9 Cisco MetroPlanner Internal Connections Table 3-49
Figure 3-10 Fibering OSC Terminations—Hub Node with OSCM Cards 3-52
Figure 3-11 Fibering a Hub Node 3-55
Figure 3-12 Fibering a Line Amplifier Node 3-59
Figure 3-13 Fibering an OSC Regeneration Node 3-61
Figure 3-14 Fibering an Amplified OADM Node 3-65
Figure 3-15 Fibering a Passive OADM Node 3-67
Figure 3-16 Fibering an ROADM Node 3-70
Figure 3-17 Using the Patch-Panel Latches to Slide the Patch Panel Away from the Tray 3-75
Figure 3-18 MPO Cable 3-76
Figure 3-19 Rear View of the Patch Panel 3-77
Figure 3-20 Top View of the Patch-Panel Bar 3-77
Figure 3-21 Front View of the Patch Panel 3-78
Figure 3-22 OSC Terminations Area 3-85
Figure 5-1 Single-Span Topology 5-4
Figure 5-2 Point-to-Point Topology 5-4
Figure 5-3 Hubs with No Line Amplifiers 5-5
Figure 5-4 Hubs with Line Amplifiers 5-5
Figure 5-5 Creating a Y-Cable Protection Group 5-11
Figure 6-1 Maintenance > Protection Tabs 6-14
Figure 8-1 Selecting CTC Data For Print 8-3
Figure 8-2 Selecting CTC Data For Export 8-4
Figure 8-3 CTC Preferences Dialog Box 8-10
Figure 8-4 Shelf LCD Panel 8-15
Figure 8-5 Store Profiles Dialog Box 8-19
Figure 8-6 AD-1C Card Alarm Profile 8-22
Figure 8-7 Select Node/Profile Combination For Delete Dialog Box 8-24