Figures
xxxv
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Figure 16-63 MXP_2.5G_10G Card Block Diagram 16-98
Figure 16-64 MXP_2.5G_10E Faceplate 16-101
Figure 16-65 MXP_2.5G_10E Block Diagram 16-102
Figure 16-66 MXP_MR_2.5G and MXPP_MR_2.5G Faceplates 16-110
Figure 16-67 MXP_MR_2.5G and MXPP_MR_2.5G Block Diagram 16-111
Figure 16-68 Laser Radiation Warning—Hazard Level Label 16-112
Figure 16-69 Laser Radiation Warning—Laser Source Connector Label 16-112
Figure 16-70 FDA Compliance Statement Label 16-112
Figure 16-71 Electrical Energy Hazard Label 16-113
Figure 16-72 Y-Cable Protection 16-115
Figure 16-73 Splitter Protection 16-116
Figure 16-74 Mylar Tab SFP 16-119
Figure 16-75 Actuator/Button SFP 16-119
Figure 16-76 Bail Clasp SFP 16-119
Figure 16-77 Bail Clasp XFP (Unlatched) 16-120
Figure 16-78 Bail Clasp XFP (Latched) 16-120
Figure 17-1 Hub Node Configuration Example 17-2
Figure 17-2 Hub Node Channel Flow Example 17-3
Figure 17-3 Terminal Node Configuration Example 17-4
Figure 17-4 Amplified OADM Node Configuration Example 17-5
Figure 17-5 Amplified OADM Node Channel Flow Example 17-6
Figure 17-6 Passive OADM Node Configuration Example 17-7
Figure 17-7 Passive OADM Node Channel Flow Example 17-7
Figure 17-8 ROADM Node with BST-PRE, OPT-BST, and 32DMX Cards Installed 17-8
Figure 17-9 ROADM Node with BST-PRE, OPT-BST, and 32DMX-O Cards Installed 17-9
Figure 17-10 ROADM Optical Signal Flow Example 17-10
Figure 17-11 Anti-ASE Node Channel Flow Example 17-11
Figure 17-12 Line Amplifier Node Configuration Example 17-12
Figure 17-13 OSC Regeneration Line Node Configuration Example 17-13
Figure 17-14 OSC Regeneration Line Node Flow 17-13
Figure 17-15 Double Terminal Protection Configuration 17-15
Figure 17-16 1+1 Protected Single-Span Link with Hub Nodes 17-16
Figure 17-17 1+1 Protected Single-Span Link with Active OADM Nodes 17-17
Figure 17-18 1+1 Protected Single-Span Link with Passive OADM Nodes 17-18
Figure 17-19 Scalable Terminal Channel Flow Example 17-20
To Next Page
Loading...
