Cisco ONS 15454 DWDM - Page 380

5-42
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G303 Provision the MXP_2.5G_10G and MXP_2.5G_10E Trunk Port Alarm and TCA Thresholds
Step 4 Referring to Table 5-21, provision the trunk port (Port 5) TCA thresholds for RX Power High, RX Power
Low, TX Power High, and TX Power Low.
Note Do not modify the Laser Bias parameters.
Step 5 Click Apply.
Step 6 Under Types, click the Alarm radio button and click Refresh.
Step 7 Referring to Table 5-22, provision the trunk port (Port 5) Alarm thresholds for RX Power High,
RX Power Low, TX Power High, and TX Power Low.
Note You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
Step 8 Click Apply.
Step 9 Return to your originating procedure (NTP).
Table 5-21 MXP_2.5G_10G and MXP_2.5G_10E Trunk Port TCA Thresholds
Card
TCA RX
Power Low
TCA RX
Power High
TCA TX
Power Low
TCA TX
Power High
MXP_2.5G_10G –22 dBm –8 dBm –1 dBm 7 dBm
MXP_2.5G_10E –18 dBm –9 dBm 0 dBm 9 dBm
Table 5-22 MXP_2.5G_10G and MXP_2.5G_10E Trunk Port Alarm Thresholds
Card
Alarm RX
Power Low
Alarm RX
Power High
Alarm TX
Power Low
Alarm TX
Power High
MXP_2.5G_10G –24 dBm –8 dBm 2 dBm 4 dBm
MXP_2.5G_10E –20 dBm –8 dBm 3 dBm 7 dBm