5-63
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G234 Change OTN Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
Table 5-39 describes the values on the Provisioning > OTN > FEC Threshold tab.
Table 5-40 describes the values on the Provisioning > OTN > Trail Trace Identifier tab.
Table 5-38 TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card ITU-T G.709 Threshold Settings
Parameter Description Options
Port
1
1. Latency for 1G-FC payload without ITU-T G.709 is 4 microseconds, and with ITU-T G.709 is 40 microseconds. Latency
for 2G-FC payload without ITU-T G.709 is 2 microseconds, and with ITU-T G.709 is 20 microseconds. Consider these
values when planning a FC network that is sensitive to latency.
(Display only) Port number. 2
ES Errored seconds Numeric. Can be set for Near End or Far End, for
15-minute or one-day intervals, or for SM (OTUk) or
PM (ODUk). Select a bullet and click Refresh.
SES Severely errored seconds Numeric. Can be set for Near End or Far End, for
15-minute or one-day intervals, or for SM (OTUk) or
PM (ODUk). Select a bullet and click Refresh.
UAS Unavailable seconds Numeric. Can be set for Near End or Far End, for
15-minute or one-day intervals, or for SM (OTUk) or
PM (ODUk). Select a bullet and click Refresh.
BBE Background block errors Numeric. Can be set for Near End or Far End, for
15-minute or one-day intervals, or for SM (OTUk) or
PM (ODUk). Select a bullet and click Refresh.
FC Failure counter Numeric. Can be set for Near End or Far End, for
15-minute or one-day intervals, or for SM (OTUk) or
PM (ODUk). Select a bullet and click Refresh.
Table 5-39 TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card FEC Threshold Settings
Parameter Description Options
Port (Display only) Port number. 2
Bit Errors
Corrected
Sets the value for bit errors corrected. Numeric. Can be set for 15-minute or
one-day intervals.
Uncorrectable
Words
Sets the value for uncorrectable words. Numeric. Can be set for 15-minute or
one-day intervals.
Table 5-40 TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card Trail Trace Identifier Settings
Parameter Description Options
Port (Display only) Port number. 2
Level Sets the level.
• Section
• Path
Trace Mode Sets the trace mode.
• Off/None
• Manual
To Next Page
Loading...
