14-4
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 14 Power Down a Node
NTP-G119 Power Down the Node
Step 14 After you have deleted the card, open the card ejectors and remove it from the node.
Step 15 Repeat Step 11 through Step 14 for each installed card.
Note You cannot delete a TCC2 or TCC2P card in Cisco Transport Controller (CTC). Physically
remove it after all the other cards have been deleted and removed.
Step 16 Shut off the power from the power supply that feeds the node.
Step 17 Disconnect the node from its external fuse source.
Step 18 Store all of the cards that you removed and update inventory records according to local site practice.
Stop. You have completed this procedure.
To Next Page
Loading...
