Cisco ONS 15454 DWDM - Page 961

20-5
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 20 Security Reference
20.2.1 User Privileges by CTC Task
Table 20-2 shows the actions that each user privilege level can perform in network view.
Maintenance OSI IS-IS RIB — — — X
ES-IS RIB ———X
TDC ———X
Protection Switch/Lock out/Lockon/ Clear/
Unlock
XXXX
BLSR (ANSI)
MS-SPRing (ETSI)
West/East Switches — — X X
Reset —XXX
Software Download — X X X
Activate/Revert — — — X
Cross-Connect Cards: Switch/Lock/Unlock — X X X
Resource Usage: Delete — — X X
Overhead
XConnect
View XXXX
Diagnostic Retrieve/Lamp Test — X X X
Timing Source: Edit — X X X
Timing Report: View/Refresh X X X X
Audit Retrieve/Archive — — — X
Routing Table Retrieve X X X X
RIP Routing Table Retrieve X X X X
Test Access Read-only X X X X
DWDM APC: Run/Disable/Refresh — X X X
WDM Span Check: Retrieve
Span Loss values, Reset
XXXX
Power Monitoring: Refresh X X X X
1. A Provisioning user cannot change node name, contact, or AIS-V insertion on STS-1 signal degrade (SD) parameters.
2. The action buttons in the subtab are active for all users, but the actions can be completely performed only by the users assigned with the required security
levels.
Table 20-1 ONS 15454 Security Levels—Node View (continued)
CTC Tab Subtab [Subtab]:Actions Retrieve Maintenance Provisioning Superuser
Table 20-2 ONS 15454 Security Levels—Network View
CTC Tab Subtab [Subtab]: Actions Retrieve Maintenance Provisioning Superuser
Alarms — Synchronize/Filter/Delete
cleared alarms
XXXX
Conditions — Retrieve/Filter X X X X
History — Filter X X X X