RUGGEDCOM ROX II
CLI User Guide
Chapter 16
Traffic Control and Classification
Configuring QoS Marking 705
• name is the name of the traffic control rule
3. Configure the following parameter(s):
Parameter Description
logic-op { logic-op } Synopsis: { and, or }
A logical operation to perform on the current mark: AND/OR.
mark-value { mark-value } Synopsis: A string
A mark to perform the operation with (decimal value).
modify-chain { modify-chain } Synopsis: { forward, postrouting, prerouting }
Default: forward
A chain in which the operation will take place.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Configuring a Save Mark
1. Make sure the CLI is in Configuration mode.
2. Configure the Save option by typing:
qos traffic-control advanced-configuration tcrules name mark-choice save
Where:
• name is the name of the traffic control rule
3. Configure the following parameter(s):
Parameter Description
value-mask { value-mask } Synopsis: A string
Mask to process the mark with
op-chain { op-chain } Synopsis: { forward, prerouting }
Default: forward
A chain in which the operation will take place.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Configuring a Restore Mark
1. Make sure the CLI is in Configuration mode.
2. Select the Restore option by typing:
qos traffic-control advanced-configuration tcrules name mark-choice restore
Where:
• name is the name of the traffic control rule
3. Configure the following parameter(s):
Parameter Description
value-mask { value-mask } Synopsis: A string
A mask to process the mark with.
To Next Page
Loading...
Need help?
General
