Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 2
Using RUGGEDCOM ROX II
Using Output Redirects 31
Parameter Description
lm4 E1 w/ 2x BNC - -
lm5 none - -
lm6 none - -
power-controller
PM MOV PM PM PM
SLOT PROTECTION TEMPERATURE CURRENT VOLTAGE
------------------------------------------------
pm1 na 43 2907 3381
For example, show chassis | begin line-modules | notab suppresses the table formatting:
ruggedcom# show chassis | begin line-modules | notab
line-modules
line-module lm1
detected module "1000TX w/ 2x RJ45"
line-module lm2
detected module none
line-module lm3
detected module "6x RS232/RS422/RS485 via RJ45"
line-module lm4
detected module "E1 w/ 2x BNC"
line-module lm5
detected module none
line-module lm6
detected module none
power-controller
PM MOV PM PM PM
SLOT PROTECTION TEMPERATURE CURRENT VOLTAGE
------------------------------------------------
pm1 na 43 2892 3381
repeat Repeats the term at the specified interval. Specify an interval in seconds. The term repeats
until you cancel it with Ctrl-C.
For example, show admin | repeat 10s repeats the show admin term every 10 seconds.
save Saves the output to the specified ASCII text file.
For example, show chassis | save foo.txt saves the chassis information to the file foo.txt
select This redirect is not yet implemented.
tab Enforces table layout for columnar data.
until Includes output until a line containing the specified text appears. Regular expressions
can be used with this redirect. For more information about regular expressions, refer to
Section2.5.7, “Using Regular Expressions”.
For example, show chassis | begin cpu | until status returns the chassis information
beginning with cpu and ending with status:
ruggedcom# show chassis | begin cpu | until status
cpu
slot-cpu main
detected module "RX1501 8 Gigabit Layer 3 w/ 6 LM slots and 1 PM
slots"
cpu load 22
ram avail 53
ram avail low 20
status

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English