Contents
xi
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
DLP- G97 Provision a Proxy Tunnel 7-15
DLP- G98 Provision a Firewall Tunnel 7-16
DLP- G107 Create an IP-Encapsulated Tunnel 7-17
DLP- G108 Change the Service State for a Port 7-18
DLP- G109 Provision Orderwire 7-19
DLP- G110 Create a User Data Channel Circuit 7-20
NTP- G61 Modify and Delete Overhead Circuits 7-21
DLP- G111 Repair an IP Tunnel 7-21
DLP- G112 Delete Overhead Circuits 7-22
NTP- G62 Create a J0 Section Trace 7-23
CHAPTER
8 Manage Alarms 8-1
Before You Begin 8-1
NTP- G63 Document Existing Provisioning 8-2
DLP- G113 Print CTC Data 8-2
DLP- G114 Export CTC Data 8-4
NTP- G64 View Alarms, History, Events, and Conditions 8-6
DLP- G115 View Alarms 8-6
DLP- G116 View Alarm or Event History 8-8
DLP- G117 Change the Maximum Number of Session Entries for Alarm History 8-9
DLP- G118 Display Alarms and Conditions Using Time Zone 8-11
DLP- G119 Synchronize Alarms 8-11
DLP- G120 View Conditions 8-12
NTP- G65 Delete Cleared Alarms from Display 8-13
NTP- G66 View Alarm-Affected Circuits 8-14
NTP- G67 View Alarm Counts on the LCD for a Node, Slot, or Port 8-15
NTP- G68 Create, Download, and Assign Alarm Severity Profiles 8-16
DLP- G121 Create a New or Cloned Alarm Severity Profile 8-17
DLP- G122 Download an Alarm Severity Profile 8-20
DLP- G123 Apply Alarm Profiles to Ports 8-21
DLP- G124 Apply Alarm Profiles to Cards and Nodes 8-23
DLP- G125 Delete Alarm Severity Profiles 8-23
NTP- G69 Enable, Modify, or Disable Alarm Severity Filtering 8-25
DLP- G126 Enable Alarm Filtering 8-25
DLP- G127 Modify Alarm, Condition, and History Filtering Parameters 8-26
DLP- G128 Disable Alarm Filtering 8-28
NTP- G70 Suppress Alarms or Discontinue Alarm Suppression 8-29
DLP- G129 Suppress Alarm Reporting 8-29
To Next Page
Loading...
Need help?
General
