Contents
xii
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
DLP- G130 Discontinue Alarm Suppression 8-31
NTP- G72 Provision External Alarms and Controls on the Alarm Interface Controller-International
Card
8-32
CHAPTER
9 Monitor Performance 9-1
Before You Begin 9-1
NTP- G73 Change the PM Display 9-2
DLP- G131 Refresh PM Counts at 15-Minute Intervals 9-2
DLP- G132 Refresh PM Counts at One-Day Intervals 9-3
DLP- G133 View Near-End PM Counts 9-4
DLP- G134 View Far-End PM Counts 9-5
DLP- G135 Reset Current PM Counts 9-6
DLP- G136 Clear Selected PM Counts 9-7
DLP- G137 Set Auto-Refresh Interval for Displayed PM Counts 9-8
DLP- G138 Refresh PM Counts for a Different Port 9-9
NTP- G74 Monitor DWDM Card Performance 9-9
DLP- G139 View Optical Service Channel PM Parameters 9-10
DLP- G140 View Optical Amplifier Power Statistics 9-12
DLP- G141 View Optical Power Statistics for 32MUX-O, 32-WSS, 32-DMX-O, and 32DMX
Cards
9-13
DLP- G276 View 4-Channel Multiplexer/Demultiplexer Optical Power Statistics 9-15
DLP- G142 View Channel Optical Add/Drop Multiplexer Power Statistics 9-16
DLP- G143 View Band Optical Add/Drop Multiplexer Power Statistics 9-18
NTP- G75 Monitor Transponder and Muxponder Performance 9-19
DLP- G144 Enable or Disable OTN ITU-T G.709 Performance Monitoring 9-20
DLP- G145 Enable or Disable OTN FEC Performance Monitoring 9-21
DLP- G146 View Optics PM Parameters 9-22
DLP- G147 View Payload PM Parameters 9-23
DLP- G148 View OTN PM Parameters 9-25
DLP- G149 View Payload Statistics PM Parameters 9-27
DLP- G150 View Payload Utilization PM Parameters 9-28
DLP- G151 View Payload History PM Parameters 9-30
DLP- G152 View Payload SONET PM Parameters 9-31
CHAPTER
10 Manage the Node 10-1
Before You Begin 10-1
NTP- G76 Verify Optical Span Loss Using CTC 10-2
NTP- G77 Manage Automatic Power Control 10-3
DLP- G157 Disable Automatic Power Control 10-4
To Next Page
Loading...
Need help?
General
