4-11
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 4 Perform Node Acceptance Tests
NTP-G43 Perform the ROADM Node Acceptance Test
For a 32DMX-O card:
a. Choose Provisioning > Optical Chn > Parameters tabs.
b. For each wavelength being tested, click the Admin State table cell and choose OOS,MT (ANSI) or
Locked,maintenance (ETSI) from the drop-down list.
c. Click Apply, then click Ye s to confirm.
Step 15 Repeat Step 14 for the west 32DMX or 32DMX-O card.
Step 16 Complete the “DLP-G310 Verify ROADM Node Pass-Through Channels” task on page 4-12.
Step 17 Complete the following tasks for channels that will be added or dropped on the node.
• DLP-G311 Verify the East ROADM Add/Drop Channels, page 4-16
• DLP-G312 Verify the West ROADM Add/Drop Channels, page 4-18
Step 18 Display the east 32WSS in card view.
Step 19 Click the Provisioning > Optical Chn Optical Connector [n] > Parameters tabs, where n = the optical
connector number that carries the wavelengths you tested.
Step 20 Click the Admin State table cell then choose IS,AINS (for ANSI) or Unlocked,AutomaticInService
(ETSI) from the drop-down list for all ports that were changed to OOS,MT or Locked,Maintenance.
Step 21 Click Apply.
Step 22 Repeat Steps 19 and 21 for all the ports that are OOS,MT or Locked,maintenance on the east 32WSS
card.
Step 23 Display the west 32WSS in card view.
Step 24 Repeat Steps 19 through 21 for all ports on the west 32WSS card.
Step 25 Display the east 32DMX in card view.
Step 26 Choose the Provisioning > Optical Line > Parameters tabs.
Step 27 For Port 33, click the Admin State table cell and choose IS,AINS (ANSI) or
Unlocked,AutomaticInService (ETSI) from the drop-down list.
Step 28 Click Apply.
Step 29 Display the west 32DMX card in card view.
Step 30 Repeat Steps 26 through 28 for the west 32DMX card.
Step 31 Delete both OSC channels using the “DLP-G186 Delete an OSC Termination” task on page 10-41.
Step 32 Complete the “NTP-G37 Run Automatic Node Setup” procedure on page 3-83.
Step 33 Create the two OSC channels using the “NTP-G38 Provision OSC Terminations” procedure on
page 3-84.
Step 34 Click the Alarms tab.
a. Verify that the alarm filter is not on. See the “DLP-G128 Disable Alarm Filtering” task on page 8-28
as necessary.
b. Verify that no equipment failure alarms appear on the node. If alarms appear, investigate and resolve
them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide or the
Cisco ONS 15454 SDH Troubleshooting Guide for procedures.
Stop. You have completed this procedure.
To Next Page
Loading...
