Cisco ONS 15454 DWDM - Page 359

5-21
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G319 Change the TXP_MR_10G or TXP_MR_10E Card Line Thresholds for 10G Ethernet LAN Phy
DLP-G319 Change the TXP_MR_10G or TXP_MR_10E Card Line Thresholds for
10G Ethernet LAN Phy
Step 1 Display the TXP_MR_10G or TXP_MR_10E card where you want to change the line threshold settings
in card view.
Step 2 Click the Provisioning > Line Thresholds > RMON Thresholds tabs.
Step 3 Click Create. The Create Threshold dialog box appears.
Step 4 From the Port drop-down list, choose the applicable port.
Step 5 From the Variable drop-down list, choose an Ethernet variable. See Table 5-7 for a list of available
Ethernet thresholds.
Purpose This task changes the line threshold settings for TXP_MR_10G and
TXP_MR_10E transponder cards carrying the physical 10G Ethernet LAN
payload.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-7 TXP_MR_10G and TXP_MR 10GE LAN Phy Variables
Variable Description
ifInOctets Total number of octets received on the interface, including framing
characters.
rxTotalPkts Total number of received packets.
ifInMulticastPkts Number of multicast frames received error free.
ifInBroadcastPkts Number of packets, delivered by a sublayer to an higher sublayer,
which were addressed to a broadcast address at this sublayer.
ifInErrors Number of inbound packets that contained errors preventing them
from being delivered to a higher-layer protocol.
ifInErrorBytePkts Number of receive error bytes.
ifInFramingErrorPkts Number of receive framing error counters.
ifInJunkInterPkts Number of receive interpacket junk counters.
ifOutOctets Total number of octets transmitted out of the interface, including
framing characters.
txTotalPkts Total number of transmit packets.
ifOutMulticastPkts Number of multicast frames transmitted error free.
ifOutBroadcastPkts Total number of packets that higher-level protocols requested be
transmitted, and that were addressed to a broadcast address at this
sublayer, including those that were discarded or not sent.