Contents
viii
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
NTP- G46 Perform the Line Amplifier Node with OSC-CSM Cards Acceptance Test 4-26
NTP- G47 Perform the Line Amplifier Node with OSCM and OSC-CSM Cards Acceptance Test 4-30
NTP- G48 Perform the OADM Node Acceptance Test on a Symmetric Node with OSCM Cards 4-34
NTP- G49 Perform the OADM Active Node Acceptance Test on a Symmetric Node with OSC-CSM
Cards
4-36
NTP- G50 Perform the OADM Passive Node Acceptance Test on a Symmetric Node with OSC-CSM
Cards
4-38
DLP- G78 Verify the 32MUX-O Power 4-40
DLP- G79 Verify the OPT-BST Amplifier Laser and Power 4-40
DLP- G80 Verify the OPT-PRE Amplifier Laser and Power 4-41
DLP- G269 Verify the 32DMX-O Power 4-42
DLP- G270 Verify the 32DMX Power 4-42
DLP- G82 Verify the OSC-CSM Power 4-43
DLP- G83 Verify the OSC-CSM Power on OADM Nodes 4-43
DLP- G84 Verify the OSC-CSM Incoming Power 4-44
DLP- G85 Verify Express Channel Connections on an OADM Node with OSCM Cards 4-44
DLP- G86 Verify Express Channel Connections on an OADM Node with OSC-CSM Cards 4-46
DLP- G87 Verify the AD-xB-xx.x Output Express Power 4-47
DLP- G88 Verify the AD-xC-xx.x Output Express Power 4-47
DLP- G271 Verify the AD-xC-xx.x Output Common Power 4-48
DLP- G272 Verify the AD-xB-xx.x Output Common Power 4-48
DLP- G89 Verify OADM Node Pass-Through Channel Connections 4-49
DLP- G90 Verify an AD-xB-xx.x Pass-Through Connection Power 4-50
DLP- G91 Verify an AD-xC-xx.x Pass-Through Connection 4-51
DLP- G92 Verify 4MD-xx.x Pass-Through Connection Power 4-52
DLP- G93 Verify Add and Drop Connections on an OADM Node with OSCM Cards 4-53
DLP- G94 Verify Add and Drop Connections on OADM Node with OSC-CSM Cards 4-56
CHAPTER
5 Provision Transponder and Muxponder Cards 5-1
Before You Begin 5-1
NTP- G128 Manage Pluggable Port Modules 5-2
DLP- G277 Provision a Multirate PPM 5-3
DLP- G274 Verify Topologies for ETR_CLO and ISC Services 5-4
DLP- G278 Provision the Optical Line Rate 5-6
DLP- G279 Change the Optical Line Rate 5-8
DLP- G280 Delete a PPM 5-8
NTP- G33 Create a Y-Cable Protection Group 5-10
NTP- G96 Modify Line Settings and PM Parameter Thresholds for TXP_MR_10G and TXP_MR_10E
Cards
5-12