Operating InstructionsFacsimile Reference (option) <Advanced Features>
78
L
LL
L
Press the {
{{
{Start}
}}
} key.
Note
❒ If you use Immediate Transmission and
the destination fax machine does not sup-
port the SUB Code feature, a message will
appear on the display to inform you of this.
In this case, press [
OK
] to cancel the trans-
mission.
SID Code
There are times when you may wish to use a
“SID” (Sender ID) when sending confidential
faxes with the SUB Code feature.
Limitation
❒ You can enter a SID using up to 20 digits.
Note
❒ You can store IDs in Quick Dials, Groups and
Programs. ⇒ Chapter 3, “Quick Dial”,
“Groups” in the Basic Features manual and,
⇒ p.153 “Registering and Changing Key-
stroke Programs”
❒ Messages you send using this feature are
marked “SID” on all reports. ⇒ p.187 “Re-
ports/Lists”
SEP Code
Normally you can only use Polling Reception to
receive faxes from machines that have the Poll-
ing Reception feature of the same make. Howev-
er, if a machine of another make supports a
Polling Reception, you can receive fax messages
from the other party using this method instead.
Poll the other machine. You can receive messag-
es that have the same SEP Code as the SEP Code
you entered.
Limitation
❒ You can only use this feature with a G3 line
(not with G4).
❒ You cannot use Chain Dial with this feature.⇒
p.73 “Chain Dial”
To Next Page
