Operating Instructions Copy Reference <Advanced Features>
77
When copying doesn't start
When a Message is Displayed
The following chart describes displayed messages as well as what to do when they appear.
Message Cause Solution & Reference
Cannot detect original size. An original with a size difficult to de-
tect has been placed. ⇒ p.136 “Sizes
Difficult to Detect”
Do not use Auto Paper Select. In pa-
per selection use other procedures ex-
cept for paper specified
magnification for Reduce/Enlarge
copies.
Make sure that the original is correct-
ly placed on the exposure glass. ⇒
“Placing Originals on the Exposure
Glass”, Basic Features manual
Originals have not been placed. Place originals in the machine.
Check original orientation. The orientation of the original is not
correct.
Change the orientation of the origi-
nal.
Maximum number of sets is *. The number of copies exceeds the
limit.
You can change the maximum num-
ber of sets to be copied one at a time.
⇒ p.107 “Max. Copy Quantity”
Check paper size. The paper is not suitable. When pressing the {
{{
{Start}
}}
} key, copy-
ing will be done on the selected pa-
per.
To Next Page
Loading...
