Operating Instructions Copy Reference <Advanced Features>
81
Combine
Problem Cause Solution & Reference
Parts of the image are not copied. You specified a reproduction ratio
that does not match the sizes of your
originals and copy paper.
When you specify a reproduction ra-
tio using Manual Paper Select mode,
make sure that the ratio matches your
originals and the copy paper.
Note
❒ Select the correct reproduc-
tion ratio before using Com-
bine mode.
When you use staple and punch to-
gether, extra margin may appear.
Change the orientation of the origi-
nals.
The blank space can be eliminated by
changing the orientation of the origi-
nals. However, the punching or sta-
pling location may not be as
expected.
Order of copies is not correct. You place the originals in the incor-
rect order.
When placing a stack of originals in
the optional document feeder (ADF),
the last page should be on the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
To Next Page
Loading...
