Replacing the Photoconductor Unit
11
1
Replacing the Photoconductor Unit
If the message "Replacement Photo-
conductor Unit is required" or "Re-
place Photoconductor Unit" appears
on the panel display, replace the ap-
propriate Photoconductor Unit ac-
cording to the indicated colors.
Note
❒ The Photoconductor Unit or units
to be replaced are indicated on the
panel display.
❒ If "Black" appears, replace the
black Photoconductor Unit.
❒ If "yellow/magenta/cyan" ap-
pears, replace the three color
(CMY) Photoconductor Units.
A
AA
A
Turn off the power switch, and
then unplug the power cable.
B
BB
B
Open the front cover slowly by
pulling down from the two areas
on the left and right.
C
CC
C
Take out the green screwdriver.
Use this screwdriver to attach and
detach all screws.
D
DD
D
Turn the light brown lever coun-
terclockwise.
E
EE
E
Loosen the two screws that fasten
the inner cover using the provid-
ed screwdriver.
You cannot remove these two
screws.
ZDJH007J
ZDJH013J
ZDJH014E
ZDJH015J
To Next Page
Loading...
