Operating Instructions Administrator Reference 2
111
Timer Setting
When entering Set Time mode, if a key operator code has been set, you must enter the code (up to 8
digits). ⇒ p.127 “User Code”
❖
❖❖
❖ Auto Off Timer
The machine turns off automatically to conserve energy after a specified amount of time has past
after a job. This function is called "Auto Off".
The machine status after the Auto Off operation is called "Off mode" or "Sleep mode". For the Auto
Off Timer, specify the time to elapse before the Auto Off function is activated.
The Time can be set from 10 seconds to 240 minutes.
Note
❒ Default: 60 minute
❒ Enter numbers with number keys
❒ Use the [←
←←
←] and [→
→→
→] keys to switch between minutes and seconds.
❒ Press [Clear] if you enter the wrong value.
❒ Auto off may not work while an error is displayed.
❒ The Auto Off function is not available in the following cases:
• When the warning display has appeared
• When paper has been misfed
• When the cover is open
• When the "Add Toner" message has appeared
• When the cartridge is being changed
• When the "User Tools/Counter" display has appeared
• During Fuser Adjust
• When the facsimile, printer or another function is in use
To Next Page
Loading...
