Operating Instructions Administrator Reference 2
112
• When operation has been interrupted during printing
• When On Hook dial is being used
• When the Quick dial or Group dial destination is being entered
• When the Data In indicator is blinking
• When the "Sample Print/Locked Print" display has appeared
❖
❖❖
❖ Panel Off Timer
Set the amount of time the machine waits before switching the panel off after copying has finished
or the last operation is performed.
Note
❒ The default setting is the same time interval as the Auto Off Timer default setting, so the Panel
Off Timer is not used. This setting is only used if the Auto Off Timer setting is set to a longer in-
terval than the Panel Off Timer setting.
❒ The default: 1 minute
❒ Enter a time interval between 10 seconds and 240 minutes with the number keys.
❒ Press the [←
←←
←] or [→
→→
→] keys to move the cursor between minutes and seconds.
❒ Press [Clear] if you enter the wrong value.
❖
❖❖
❖ System Reset Timer
The System Reset setting is a setting that automatically switches to the screen for the function set in
Function Priority. This happens if no operations are performed or when an interrupted job is cleared.
This setting sets the system reset interval.
Note
❒ Default: Yes, 60 seconds
❒ The time can be set from 10 to 999 seconds.
❒ Press [Clear] if you enter the wrong value.
To Next Page
Loading...
