Lanier Copier System Edition - Smartnetmonitor for Admin

Operating Instructions Administrator Reference 2
181
SmartNetMonitor for Admin
A
AA
A
Run SmartNetMonitor for Admin.
B
BB
B
Click the [Group] menu, point to [Open LAN], and select [TCP/IP] or [IPX/SPX]. A list of printers
appears.
Note
❒ Select the protocol of the printer you want to change the settings.
C
CC
C
On the list, click to select the printer whose network interface board you want to change the
settings.
D
DD
D
From the [Tools] menu, select [NIB Setup Tool].
The NIB Setup Tool starts up.
E
EE
E
Select [Property Sheet], and then click [OK].
TCP/IP
A Click the [General] tab, and then type the name into the [Device Name] box and comment
into the [Comment] box.
• In the [Device Name] box, type the name of the printer within 47 characters. The factory de-
fault name consists of "RNP" and the last 3 bytes of the MAC address of the network interface
board. For example, when the MAC address is 00:00:74:62:7D:D5, the factory default name
is "RNP627DD5". No name of 9 characters is permitted if prefixed with "RNP". Also, when
DHCP is selected as an IP address setting, the number of characters is limited to within 13
characters.
• In the [Comment] box, type any comment on printers within 31 characters.