Operating Instructions Administrator Reference 2
182
NetBEUI
A Click the [General] tab, and then type the comment into the [Comment] box.
In the [Comment] box, type any comment on printers within 31 characters.
B Click the [NetBEUI] tab.
C Type the name into the [Computer Name] box.
• In the [Computer Name] box, type the name that helps you to identify printers using the Net-
BEUI protocol. The factory default name consists of "RNP" and the last 3 bytes of the MAC
address of the network interface board. For example, when the MAC address is
00:00:74:62:7D:D5, the factory default name is "RNP627DD5". A maximum of 13 charac-
ters of capital English letters, numeric, or symbols (except "*+,/:;<=>?[\]|. and space) can be
used. No name is permitted if prefixed with "RNP". You must avoid the duplication of the
same name on a network.
• In the [Comment] box, type any comment on printers within 31 characters.
F
FF
F
Click [OK].
The NIB Setup Tool exits, and the setting is transmitted to the printer.
G
GG
G
Exit SmartNetMonitor for Admin.
To Next Page
Loading...
