Operating Instructions Administrator Reference 2
242
Printing after resetting the printer
After resetting the remote printer, it will be cut off from the print server for about 30-40 seconds before
connecting again. Due to the NetWare specification, print jobs may be accepted, but they will not be
printed during this interval.
When using the printer as a remote printer, wait about 2 minutes after resetting the printer before at-
tempting to print.
When Using DHCP
Note the following points when using DHCP (Dynamic Host Configuration Protocol).
Select "DHCP" for "Network Boot" on the panel display, If you use DHCP. See Administrator Refer-
ence 1 for more information.
Configure the printer with a reserved IP address
To always assign the same IP address, configure a reserved IP address using the DHCP server.
Note
❒ When multiple DHCP servers are used, reserve the same address with each DHCP server. The Net-
work Interface Board needs to receive information from the DHCP server that it contacts.
❒ If you do not know the MAC address, it can be found on the configuration page printed by the printer.
❒ For details about the settings for IP address, see the Help files for the operating system you use.
❒ When you select the printer in the DHCP environment using SmartNetMonitor for Client, use the
printer name that is displayed with SmartNetMonitor for Admin or shown on the configuration page.
To Next Page
Loading...
