Lanier Copier System Edition - Configuring Netbeui for Printing

Operating Instructions Administrator Reference 2
30
Configuring NetBEUI for Printing
Follow these instructions to configure the Network Interface Board and Windows NT to use the Net-
BEUI protocol.
Configuring the printer
Configure the printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is active.)
Reference
For more information about how to make the above settings, see "Windows NT 4.0 Configuration"
in Printer Client Reference 1 that comes with this printer.
Configuring a Windows NT computer
Install the NetBEUI protocol on the Windows NT computer, and change the LAN adapter number (La-
na Number).
A
AA
A
Open [Control Panel] and double-click the [Network] icon. Confirm that "NetBEUI Protocol" is
listed in the [Network Protocols] box under the [Protocols] tab.
Note
❒ If the NetBEUI protocol is not installed, click [Add...] under the [Protocols] tab, and install it. For
more information about installing the NetBEUI protocol, see Windows NT Help file.
B
BB
B
Change the Lana Number. Click the [Services] tab, click "NetBIOS Interface" in the [Network
Services:] box , and click [Properties:].