Lanier Copier System Edition - Remote Maintenance by Telnet; Using Telnet

Operating Instructions Administrator Reference 2
198
Remote Maintenance by telnet
You can view the printer status and configure the Network Interface Board using telnet.
Note
❒ You should specify a password so that only the network administrator, or a person having network
administrator privileges, can use remote maintenance.
Using telnet
The following is a sample procedure in using telnet.
Limitation
❒ Only one person at a time can be logged on to do remote maintenance.
A
AA
A
Using the IP address or host name of the printer, start telnet.
% telnet IP_address
Note
❒ In order to use the host name instead of the IP address, you must write it to the /etc/hosts file.
B
BB
B
Type the password.
Note
❒ The factory default is "password".
C
CC
C
Type a command.
Reference
For more information about telnet commands, see p.199 “Commands List”.