Lanier Copier System Edition - Setting up as a Remote Printer

Operating Instructions Administrator Reference 2
57
Setting Up as a Remote Printer
A
AA
A
Log on to the file server as an Admin or an Admin equivalent.
B
BB
B
Run the SmartNetMonitor for Admin.
C
CC
C
Click the [Group] menu and click [Open LAN] and select [IPX/SPX].
A list of printers appears.
Note
❒ If you cannot identify which printer to configure from the list of printers, print Configuration Page
from the printer and find the desired printer. For more information about printing Configuration
Page, see p.161 “Printing a Configuration Page”.
❒ If no printer name appears in the list, match the frame types of the IPX/SPX protocol between
the computer and printer. Use the [Network] dialog box of Windows to change the frame type of
the computer. For more information about changing the frame type of equipment, see "Config-
uring the Printer for the Network" in Administrator Reference 1.
D
DD
D
Click to select the printer you want to configure, and then click [NIB Setup Tool] on the [Tools]
menu.
E
EE
E
Click to select [Property Sheet] and click [OK].
F
FF
F
Click the [NetWare] tab, and make the following settings.
A In the [Print Server Name] box, type the name of the print server.
B In the [File Server Name] box, type the name of the file server in which a print server is to be
created.
Clicking [Browse], you can select a file server among those listed in the [Browse] dialog box.