When the {Facsimile} Key is Lit in Red
75
4
When the {
{{
{Facsimile}
}}
} Key is Lit in Red
If this key is lit, refer to the table below and take the appropriate action.
Problem Solution
Paper has run out. Add paper.
⇒ “Loading Paper” in Maintenance Guide 2
Copier System Edition
The paper output tray is full. Remove the paper from the tray.
The machine is in RDS (Remote Diagnostic
System) mode.
Wait with the main power switch on. The ma-
chine will enter the standby mode after it exits
from the RDS mode.
A facsimile error has occurred. The facsimile has a problem. Contact a service
representative. The copier will still function
normally.
To Next Page
Loading...
