Operating InstructionsFacsimile Reference (option) <Advanced Features>
137
Transfer Result Report
This reports whether transmission to the End Re-
ceivers was successful or not.
Preparation
❒ Program the Requesting Party fax number
into a Quick Dial key in advance. ⇒ Chapter
3, “Quick Dials” in the Basic Features manual
When the Transfer Station has transferred the
message to all End Receivers, it sends the Trans-
fer Result Report back to the Requesting Party.
The machine prints the report if it cannot be sent
back to the Requesting Party. You must program
the fax number of the Requesting Party in Quick
Dial in the Transfer Station.
Note
❒ You can set whether a portion of the original
image is printed on the report with the User
Parameters. ⇒ p.216 “Changing the User Pa-
rameters” (Switch04, Bit7)
JBIG Reception
The optional Fax Function Upgrade Unit is re-
quired.
It allows you to receive messages sent in the
JBIG format.
Limitation
❒ If ECM is turned off, JBIG Reception is not
available.
❒ This feature is not available with G4 commu-
nication.
❒ When the optional Extra G3 Interface Unit is
installed, JBIG receptions of “G3-2” lines are
standard.
To Next Page
Loading...
