Operating Instructions Administrator Reference 2
117
❖
❖❖
❖ Ethernet Speed
Set the access speed for networks.
Select a speed that matches your network environment. "Auto Select" should usually be specified.
Note
❒ Default: Auto select
Interface Settings/Parallel Interface
❖
❖❖
❖ Parallel Timing
Specifies the timing setting for the parallel interface. Under normal circumstances, you will not need
to change this setting.
Note
❒ Default: ACK outside
❖
❖❖
❖ Parallel Communication Speed
Specifies the communication speed for the parallel interface. If the communication speed is set too
fast, data transfers may not flow smoothly. If this occurs, change the setting to “Standard”.
Note
❒ Default: High speed
❖
❖❖
❖ Selection Signal Status
Specifies the level for the select signal setting of the parallel interface.
Note
❒ Default: High
To Next Page
