Operating Instructions Copy Reference <Advanced Features>
80
Adjust Image
Problem Cause Solution & Reference
In Double Copies mode, parts of the
original image are not copied.
Combination of original and copy pa-
per is not correct.
Select A3L for A4 originals K, and
A4 for A5 originals.
In Border, Center, or Center/Border
mode, parts of the original image are
not copied.
You set a wide erased margin. Make the margin width narrower.
You can adjust it between 2-
99mm.⇒ p.117 “Erase Original
Shadow in Combine”, p.117 “Erase
Center Width”
Originals are not scanned correctly. Place the originals correctly.
In Margin Adjustment mode, parts of
the original image are not copied.
You set a wide erased margin. Set a narrower margin with the User
Tools. You can change it between 0-
30 mm. ⇒ p.115 “Front Margin:
Left/Right”, p.115 “Back Margin:
Left/Right”, p.115 “Front Margin:
Top/Bottom”, p.116 “Back Margin:
Top/Bottom”
There is a lack of margin space on the
opposite side of the binding position.
In Image Repeat mode, the original
image is not copied repeatedly.
You selected copy paper the same
size as originals, or you did not select
the proper reproduction ratio.
Select copy paper larger than the
originals. Select the proper reproduc-
tion ratio.
To Next Page
Loading...
