EasyManua.ls Logo

Lanier Copier System Edition - To Stop Scanning Temporarily; When Memory Reaches 0; To Remove Paper from the Staple Unit

Default Icon
1270 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Basic Copying
54
1
To Stop Scanning Temporarily
When you are using the Sort, Stack, or
Staple function, the originals are
scanned into memory.
A
AA
A
Press the {
{{
{Clear/Stop}
}}
} key to stop
originals from being scanned into
memory.
The confirmation screen is dis-
played.
To continue scanning
A Press [Continue] to continue
scanning.
Note
Scanned images in memory
are not cleared.
To clear scanned images of the
originals
A Press [Stop].
Scanning is stopped and the im-
ages cleared.
When Memory Reaches 0%
Scanning will be stopped if the size of
scanned image data exceeds memory
capacity.
Note
There is enough memory to store
approximately 200 (Color
mode)/800 (Black & White) origi-
nals of A4, 8
1
/
2
" × 11" size. The
number of originals that can be
stored in memory varies depend-
ing on the memory setting and
original type. In addition, the
number of originals that can be
stored in memory will be reduced
when you use other functions.
Scanning will stop when memory
reaches 0% during sorted copying.
However, you can change this set-
ting so that all the scanned pages
are copied and delivered to the
tray. After which the machine au-
tomatically continues scanning the
remaining originals. Memory
Full Auto Scan Restart, Advanced
Features manual
A
AA
A
Press the {
{{
{Start}
}}
} key.
The scanned pages are delivered to
the tray. Then, the image data in
memory is cleared.
B
BB
B
Remove the copies, and then con-
tinue copying by following the
instructions on the display.
To Remove Paper from the
Staple Unit
If you cancel a stapling copy in the
middle of the job, paper might be left
in the optional 2 Tray Finisher. In this
case, remove the paper from the op-
tional 2 Tray Finisher.
A
AA
A
Press the {
{{
{Clear Modes}
}}
} key to can-
cel the copy settings.
B
BB
B
Place the next original, and then
press the {
{{
{Start}
}}
} key.
The paper left in the optional 2
Tray Finisher is automatically de-
livered, and then the next job
starts.
Note
When paper is not delivered
and a message is displayed, fol-
low the instructions on the dis-
play to remove the paper.

Table of Contents

Related product manuals