Operating Instructions Administrator Reference 2
29
Configuring a Windows NT computer
Follow these steps to configure a Windows NT computer to use the TCP/IP protocol.
A
AA
A
Open [Control Panel] and double-click the [Network] icon. Confirm that "TCP/IP Protocol" is
listed in the [Network protocols] box under the [Protocols] tab.
Note
❒ If the TCP/IP protocol is not installed, click [
Add
] under the [
Protocols
] tab and install it. For more
information about installing the TCP/IP protocol, see Windows NT Help file.
B
BB
B
Configure the TCP/IP protocols with the appropriate IP address, subnet mask and other set-
tings.
Confirm with the network administrator that the settings are correct.
C
CC
C
Click the [Services] tab, and confirm that "Microsoft TCP/IP Printing" is installed.
If "Microsoft TCP/IP Printing" is not installed, click [Add] under the [Services] tab, and install it.
For more information about installing and configuring network services, see Windows NT Help file.
To Next Page
Loading...
