Operating InstructionsFacsimile Reference (option) <Advanced Features>
295
Limitation
❒ There may be a difference in the size of the image when it is printed at the destination.
❒ If you place an original larger than A3/11"×17" on the exposure glass, only an are a of A3/11"×17"
is scanned.
Note
❒ Even if an original is correctly placed on the exposure glass or in the optional Document Feeder
(ADF), a margin of 3mm (0.1") around each edge of the original may not be sent.
❒ If the receiver uses paper of smaller width than the original, the image will be reduced to fit the pa-
per. ⇒ p.117 “Auto Reduce”
❒ The machine detects paper sizes in the following ways:
• When you place an original in the optional Document Feeder (ADF), an original wider than about
268mm (10.5") is scanned as A3/11"×17" size.
An original narrower than about 235mm (9.2") will be sent as 8
1
/
2
"×11" or 8
1
/
2
"×14" size.
Originals up to 1,200mm (47") in length can be scanned.
• Refer to the table below for the sizes the machine can detect when you place an original on the
exposure glass. Because the machine scans in non-standard size documents as one of the stan-
dard sizes, parts of the image may be truncated depending on the length of the document. For
details about how to set non-standard size documents. ⇒ p.183 “Programming and Changing a
Scan Size”
To Next Page
Loading...
